Download this FF120D Instruction Manual HERE in PDF Adobe Reader file
Mount the FF120D to a solid bulk head or other solid surface capable of supporting at least 35 pounds.
There MUST BE 10" of clearance above the cover of the filter on the unit so you can remove the filter, and 3" of clearance below the clear bowl, so you can
drain the water out as it accumulates.
Use the two mounting holes molded in to the side of the FF120D enclosure. Use stainless screws of adequate length with washers, through bolting the unit is the preferred mounting method ( again use s.s. screws and washers). We are in no way responsible for mistakes made during or after installation. It is 100% up to the
purchaser / end user to make sure the FF120D is installed / mounted / secured properly. If you are not sure what your doing, ALWAYS, ALWAYS, hire someone who is qualified and capable to do the installation for you.
FF120D RUNS ON 12 VOLT DC SIMPLE 2 WIRE CONNECTION
RED IS + (POSITIVE) BLACK IS – (NEGATIVE)
Wire the unit to a 15 amp 12 volt breaker, when used in boat applications, or to a 12 volt source with a 15 amp fuse in other applications. Use a minimum 14 gauge wire for distances less than 40' away from 12 volt source and 12 gauge wire for installations over 40' from 12 volt power source.
The lower right hand 3/8" barb is IN from your tank pick up. The upper left hand 3/8" barb is OUT to your return supply to the tank. ( Note barb size may be changed to 1/2” to accommodate your hose I.D. requirements)
IMPORTANT: Use fuel compatible pipe thread sealant if changing barbs or adding valves. If you are not sure what your doing, ALWAYS, ALWAYS, hire someone who is qualified and capable to do the installation for you. Use new stainless steel clamps and new, fuel rated hose. We are in no way responsible for mistakes made during
or after installation. It is 100% up to the purchaser / end user to make sure the FF120D is installed / mounted correctly.
